Using Fieldbus Only - CD Automation REVO C 2PH 690V User Manual

REVO C 2PH from 60A to 800A - 690V

13.4 Using FieldBus only

The static unit as an option can be ordered with a FieldBus (Ex: profinet).
This option continuously writes the values on the unit keeping them up to date.
Using the field bus it is possible to change the status of the Sw
the communication manual of the respective FieldBus).
Sw
NOTE:
The parameters written are:
• command table
• reference
• rescaling
if the FieldBus is active but disconnected these values will be forced to 0.
DI
DI Function Configurated like "Not Used" or different from "Enable"
= Switch software
S
contact with bit 2 of the "Command table" (See
S
Software switch
from communication
Sw
s
Instrument Enable
72
User's manual