Using Fieldbus Only - CD Automation REVEX PA User Manual

REVEX
PA from 35A to 90A

13.4 Using FieldBus only

The static unit as an option can be ordered with a FieldBus (Ex: profinet).
This option continuously writes the values on the unit keeping them up to date.
Using the field bus it is possible to change the status of the Sw
the communication manual of the respective FieldBus).
Sw = Switch software
S
NOTE:
The parameters written are:
• command table
• reference
• rescaling
if the FieldBus is active but disconnected these values will be forced to 0.
Software switch
from communication
DI
DI Function Con gurated like "Not Used" or di erent from "Enable"
contact with bit 2 of the "Command table" (See
S
Sw
s
Instrument Enable
56
User's manual