Using Fieldbus Only - CD Automation REVEX 2PH User Manual

REVEX
2PH from 30A to 40A

13.4 Using FieldBus only

The static unit as an option can be ordered with a FieldBus (Ex: profinet).
This option continuously writes the values on the unit keeping them up to date.
Using the field bus it is possible to change the status of the Sw
the communication manual of the respective FieldBus).
DI Function Con gurated like "Not Used" or di erent from "Enable"
Sw = Switch software
S
NOTE:
The parameters written are:
• command table
• reference
• rescaling
if the FieldBus is active but disconnected these values will be forced to 0.
Software switch
from communication
Sw
s
DI
Instrument Enable
contact with bit 2 of the "Command table" (See
S
55
User's manual