Installing Software And Documentation; Initialization - GRASS VALLEY NV9649 User Manual

A second power connection is for redundancy only (protection against failure) and is
not a requirement for operation.
Refer to
also
4 Connect tally (GPIO) input devices and output devices at the DB25 GPI connector.
You can use the optional WC0053 breakout cable to make these connections.
See chapter 6, GPIO, on page 129 for detail regarding the tally interface.

Installing Software and Documentation

This document is available through the Grass Valley web site.
You must use NV9000-SE Utilities to configure the NV9649 control panel. Contact Grass
Valley if you need to obtain the latest version of this NV9000 configuration software.
You may use the Panel IP Configuration Utility if you want to your NV9649 to have a static IP
address (with respect to the NV9000) or to use DHCP. The panel, as it comes from the
factory, defaults to DHCP.

Initialization

Before your NV9000 system controller can communicate with an NV9649, you must give it a
panel ID. Follow these steps for each NV9649 you are installing:
1 Power up the NV9649. Do not connect its Ethernet cable. (Disconnect it if it is
connected.)
After a few seconds, the display will show either 'No Service' or 'Acquire IP Address' at
the top left and show the panel's current panel ID:
PANEL ID PANEL ID
The menu button, with which to access the setup functions, is at the lower right.
2 Press the menu button. The panel now displays a menu of 3 items:
PANEL ID PANEL ID
Press 'Enter Panel ID' to go to the panel ID menu. Or press 'Exit' to leave the menu.
Power Specifications, on page 135 for details on the PS0001 power supply. See
Power Cord Retention, on page 142.
NO NO
NV9649 NV9649
SERVER SERVER
6491 6491
ENTER ENTER SOFTWARE SOFTWARE PANEL PANEL
TEST TEST
VERSIONS VERSIONS
MODE MODE
MENU MENU
EXIT EXIT
NV9649
User's Guide
13