Table of Contents
Advertisement
Installation
Installation
Installation
Follow these steps to install a NV9649 control panel:
1 Mount, and secure, the panel(s) in the rack.
The NV9649 is designed to mount in a 19© rack. Rack-mounting is not a requirement.
The NV9649 is a 2RU half-width panel: you can install two of them side by side in a rack.
Rack mounting (either one or two NV9649s) requires a rack mounting bracket such as
the one in Grass Valley's NV9649-48-RMK (rack-mounting kit). The kit contains two
parts, (1) the bracket itself and (2) a filler plate for brackets that will hold only one panel.
The kit provides 8 mounting screws for attaching the panels to the bracket.
The NV9649 mounts on the kit's bracket using 4 screws. The bracket has two apertures
in which the connectors at the rear of the panel are exposed:
NV9649
The filler plate and the NV9649 attach to the bracket in the same way. Each may be
placed on either side of the bracket.
See Drawings, on page 138 for bracket dimensions.
Once the panel(s) are attached to the bracket, you can place the bracket in position in
your rack. Attach the bracket to the rack frame, using screws appropriate for your rack.
The bracket's mounting slots are spaced 3.00 in(76.2 mm) vertically and allow
approximately 1/8 in (3 mm) of movement horizontally.
2 We assume that you have an Ethernet switch connected to the "Panel and Router
Network" port of your system controller. Connect an Ethernet cable from that switch to
the RJ-45 port at the rear of the NV9649.
3 Connect one or both power supplies. First connect the 4-pin connector to PS1 or PS2
on the rear of the router. The connectors are keyed and snap into place. There is only
one way they fit. Do not force them. Then connect the power supply to AC power.
12
FIller Plate
n.c.
3
1
12 VDC
12 VDC
1
n.c.
4
2
GND
GND
2
Receptacle
3
n.c.
4
n.c.
Plug
Rack-Mounting
Bracket
Advertisement
Table of Contents
