GRASS VALLEY NV9649 User Manual page 137

Press that button to proceed to the display test.
The display test should show that the pixels of the character elements of the displays are
brightly lit.
Press the 'Push to Test' button again to start the color test. The first segment of this test
shows all the buttons illuminated in high-tally green. Press the 'Push to Test' button again.
The next segment shows low-tally green.
Keep pressing that button until all the colors have been displayed — green, amber, yellow,
red, blue, purple, grey, and white and high and low-tally for each. At this point, the displays
now read button test. Pause for a moment. Do not press 'Exit':
B U T T O N
BUTTON BUTTON
NUMBER NUMBER
12 12
T E S T
B u t t o n 1 2
Press any button — except the 'Exit' button — to test it. The button will flash a few times
rapidly and the number of the button will appear on the display.
Pressing the exit button will terminate the button test and return you to the initial display
of setup mode. At this point — if you have a assigned your NV9649 a suitable panel ID —
you may connect your NV9649 to the panel network of your NV9000 system.
EXIT EXIT
NV9649
User's Guide
127