Table of Contents
Advertisement
Operation
Client-Server Model Procedures
2 Select a destination device by (1) turning the knob or (1) selecting the category and
device index using a "keypad. " Use the method described under procedures A or B. But
because you have placed the NV9649 in destination mode, the method selects a
destination.
3 Press an 'Assign' button on the NV9649.
4 Press any source button in the intended control unit of the intended NV9649. (To help
you do this, the source buttons of NV9649s — and only the source buttons — will be
lighted.)
Note: because the NV9649 is in destination mode, the new destination mnemonic will
immediately appear in the display of the intended control unit.
Procedure E — Takes Using Source Buttons
To perform a take to a single destination using an NV9649 control unit having standard
source buttons:
1 Press a source button in the control unit that corresponds to your intended destination.
The source becomes selected and the source button goes high-tally. The take button in
the same control unit goes high-tally red.
2 Press the take button. The take is completed.
Procedure F — Takes Using Quick Source Buttons
To perform a take to a single destination using an NV9649 control unit having quick source
buttons:
1 Press a quick source button in the control unit that corresponds to your intended
destination.
2 2) That source is immediately taken to the destination of that control unit.
Procedure G
To perform a 'Take All':
1 Ensure that the NV9649 is in source mode. Press the 'Source Mode' button or press a
'SRC/DST Mode' button if the panel is in destination mode.
2 Use procedure A or procedure B described above to select (i.e., preset) the desired
source.
3 Press a 'Take All' button on the NV9649.
4 The source is taken to the destinations of all NV9649 control units, regardless of how
many there are.
Procedure H — Perform Device Selection by Category List
An NV9649 panel in server mode can be configured to allow operators to perform device
selection by category list. When the NV9649 is so configured, it shows 'CatLists' in the 'Info'
display.
This method involves using the panel's knob.
To perform device selection by category list:
1 Place the panel in either source mode or destination mode, as you need.
114
Advertisement
Table of Contents
