Table of Contents
Advertisement
Configuration
Tally (GPIO) Window
Type
Take
Undefined
Tally (GPIO) Window
Below the tree window is the tally section of the configuration page.
It has two sections: inputs and outputs. By clicking on one of the input or output buttons,
you can configure the input or output.
(The NV9649 has no actual tally buttons. These buttons represent the DB25 connector at
the rear. The buttons are present in the configuration page to allow you to configure the
tally interface.)
If you are interested in configuring the tally interface, read chapter 6, GPIO, on page 129.
Global Navigation
NV9000-SE Utilities supports what are known as "global navigation" pages for NV9649
control panels. Global navigation pages are templates — patterns — that may be used and
reused in the creation of NV9649 configurations.
Global navigation pages are allowed only under the LCD XY/MD model.
There are two types of global navigation pages: 'Suffix' and 'Navigate' . A navigate template
may define a single button page or an entire subtree of pages. A suffix template is a single
page only. The buttons allowed in a suffix template are a small subset of the buttons
supported by NV9649 configurations. Navigate templates support all functions except
'Global Navigate' . That is because templates cannot be nested.
Templates themselves are not NV9649 configurations.
76
Description (under NV9609 Mode)
In normal mode, a take button routes the preset source to the selected
destination on selected level or levels.
In salvo mode, a take button executes a selected salvo.
A take button is disabled (and dark) until it is possible for the operator to
execute a take.
Configurers should provide the operator a 'Take' button. The button
definition has no fields to configure. Its legend is arbitrary.
This button type is a placeholder: during configuration, it makes the button
undefined and inactive. On the actual panel, the undefined button remains
unlit (dark).
Advertisement
Table of Contents
