GRASS VALLEY NV9649 User Manual page 48

Configuration
Configuration Page for the LCD XY/MD Model
Default
Destination
Preset Monitor
Status Monitor
XY Data
Routing Mode
38
None After a reset, the panel displays no destination device. (This
is not recommended.)
‹device› The Panel uses the specified device as the destination after a
reset. (The 'Default State' button also returns the panel to
this destination.)
None The preset source video is not sent to a monitor.
‹device› The preset source video for the selected destination appears
on the specified monitor (device).
None The current source video is not sent to a monitor.
‹device› The current source video for the selected destination
appears on the specified monitor (device).
Automatic If a machine control (i.e., data) level is involved in a route, the
system makes the route on the control level even if the
control port is in use on the source or destination device. It
breaks the previous control connection and then makes a
new control connection for the route in progress.
Semi-automatic If the control port is in use for the source or destination
(recommended) device, the system takes all (selected) levels except control
and allows the operator to perform the control level route
by pressing 'Take' a second time. The operator may cancel
the control-level take by pressing a button other than 'Take. '
If the control port is not in use, the control level take occurs
normally.
Manual If the control port is in use for the source or destination
device, the system takes all (selected) levels except control.
It does not perform the control level route.
If the control port is not in use, the control level take occurs
normally.
To carry out a take on a machine control port that is in use,
the operator must first free the port by performing a
"tristate" take on the port, that is, taking the device (as a
source) to itself (as a destination) on the control level.
A take can occur on the machine control level if, in the status
column of the display, the source entry is "FREE. "