Installing Software And Documentation; Initialization - GRASS VALLEY NV9000 User Manual

Installation

Installing Software and Documentation

2 We assume that you have an Ethernet switch connected to the "Panel and Router
Network" port of your system controller. Connect an Ethernet cable from that switch to
the RJ-45 port at the rear of the panel.
3 Connect power.

Installing Software and Documentation

This document is available through the Grass Valley web site.
You must use NV9000-SE Utilities to configure the NV9616 or NV9608 control panel.
Contact Grass Valley if you need to obtain the latest version of this NV9000 configuration
software.
You may use the Panel IP Configuration Utility if you want to your panel to have a static IP
address (with respect to the system controller) or to use DHCP. The panel, as it comes from
the factory, defaults to DHCP.

Initialization

Before your system controller can communicate with your panel, you must give it a panel
ID. Follow these steps for each NV9616 you are installing:
1 Power up the panel. Do not connect its Ethernet cable. (Disconnect it if it is connected.)
After a few seconds, the LCD buttons will show 'Acquire IP Address' on the second
button and the panel's current panel ID on the first button. The right-hand button is
designated the menu button:
NV9616 NV9616
PANEL ID PANEL ID
2 Press the menu button. The menu appears:
PANEL PANEL
ID ENTRY ID ENTRY
The menu has three submenus. Press the 'Panel ID Entry' button.
10
ACQUIRE ACQUIRE
IP IP
0 0 ADDRESS ADDRESS
SOFTWARE SOFTWARE PANEL PANEL
VERSIONS VERSIONS TEST TEST
MODE MODE
MENU MENU
EXIT EXIT