Part Numbers - Galil Motion Control DMC-21 5 Series User Manual

Part Numbers

The DMC controller board comes in two sizes, 1-4 axis models (labeled A-D) and 5-8 axis models (labeled E-H). The
number of axis is designated by x in the part number DMC-21x5.
The full DMC-21x5 part number is a combination of the DMC controller part number (DMC-21x5), controller board
options, and optional accessory types, where Y is option for the controller or accessory.
The placement of the AMP/SDM options is extremely important for 5-8 axis models. The first AMP/SDM (Axis A-D)
will be placed for the first bank of axes and the second AMP/SDM (Axis E-H) will be placed for the second bank.
Figure 1.1: Layout of DMC-21x5 with one bank of axes and layout of DMC-21x5 with two banks of axes
Please use the DMC-21x5 part number generator to check the validity of all part numbers before ordering:
https://galil.com/order/part-number-generator/dmc-21x5
DMC, "DMC-21x5(Y)" Options
Option Type
x 1, 2, 3, 4, 5, 6, 7, and 8
Y
DC24, DC48
Chapter 1 Overview ▫ 2
Options
Number of controller axis
DIN
UP Upward Facing 96 Pin DIN Connector
DOWN Downward Facing 96 Pin DIN Connector
Vertical RS232, Status Lights, and
V
Horizontal RS232, Status Lights, and
H
VP Vertical Power Connector
HP Horizontal Power Connector
RA Right Angle 96 Pin Connector
MO Motor Off Jumper Installed
TRES Termination Resistors
Table 1.1: List of DMC options
Brief Description
DIN Rail Mounting
Ethernet
Ethernet
DC to DC Converter
Documentation
N/A
DMC, "DMC-21x5(Y)" Options starting on
pg 138
DMC-21x5 User Manual 1.0a1