Spray Regulation - KaVo Key Laser III 1243 Instructions For Use Manual

Instructions for use KEY Laser III 1243
|
4 Operation

4.18 Spray regulation

4.18 Spray regulation
The amount of spray water is of great importance for ensuring that the laser treat‐
ment is performed effectively. During use of the handpiece 2060, the amount of
spray water is set so that, when a surface is sprayed, a thin film of water forms on
it. Water flow and aspiration should be tailored to the laser parameters. The chan‐
nels should be cleaned with the jet needle with reduced water flow.
See also: Handpiece-instructions
Note
Ensure that the laser tube is inserted into the input coupling and is screwed tight
and that a handpiece is mounted.
Ensure that the KEY Laser 1243 is switched to the standby mode.
▶ Set "Air and water" by choosing medium preselection
See also: 4.11 Spray settings, Page 55
▶ Remove the handpiece from the support and pull it forward until the priority logic
switch is actuated.
▶ Continuously pressing the key now causes spray to be emitted.
The spray or water flow rate is regulated by the setscrew
Turning counter clockwise increases the water flow rate (long tick marks) and turning
clockwise reduces the water flow rate (short tick marks).
70/99