Assembly Notes; Characteristics Of The Floor - KaVo Key Laser III 1243 Instructions For Use Manual

Instructions for use KEY Laser III 1243
|

9 Assembly notes

9.1 Characteristics of the floor

9 Assembly notes
9.1 Characteristics of the floor
The quality of the floor surface must correspond to a load-bearing capacity for
structures according to DIN 1055 Sheet 3 and must have a compressive strength
according to DIN 18560 T1.
The KEY Laser 1243 is delivered with soft castors from the factory.
Note
The castors may not be used on soft floor coverings (carpeting, etc.).
The floor topping, floor covering, adhesive and floor seal must be suitable for chair
castors.
In the event of improper use on other floor coverings, KaVo shall assume no liability
for any damage.
93/99