Section C: Replacing The Imaging Station Air Filter - Hologic ThinPrep Imager Duo Operator's Manual

5
I
MAGER
SECTION
The Imaging Station air filter should be replaced yearly.
Refer to Ordering
Information for
replacement air
filters.
1. Turn off power to the Imaging Station (refer to Shutting Down the Image
2. Loosen the four thumb screws at each corner of the air filter cover panel.
3. Lift off the cover panel and set it aside.
4. Remove the air filter cartridge. (Figure 5-10.)
5. Install the replacement cartridge, replace the cover panel and tighten the
5.6 Imager Duo Operator's Manual
D M
UO AINTENANCE
REPLACING THE IMAGING STATION AIR FILTER
C
Air Filter Cover
Panel
Thumb Screws
Processor on page 3.29.)
(Figure 5-9.)
Figure 5-10 Air Filter Cartridge
retaining screws.
Figure 5-9 Air Filter Location