Hologic ThinPrep Imager Duo Operator's Manual page 70

3
O
PERATION OF THE
3. At the Server, push on the power button. See Figure 3-3.
4. At the rear of the Imaging Station (Figure 3-4), position the Power rocker-
Note:
Firewire conn.
to IPC
3.4 Imager Duo Operator's Manual
I D
MAGER
Figure 3-3 Power on the Server
switch to ON (l).
The Imaging Station should be turned on before turning on the Image
Processor Controller.
Turning on power to the Imaging Station initiates a 2-minute warm-up
cycle. During this time, the sliding doors are locked to prohibit loading
and unloading of Slide Cassettes.
USB conn Serial conn
to IPC to IPC
Rear
Figure 3-4 Imaging Station, Power Switch
UO
Power On Button
Note - depending on which
model computer you have, it
may look different than this
graphic
Power
Switch
Power On Indicator
Service
Port
Front