Hologic ThinPrep Imager Duo Operator's Manual page 90

3
O
PERATION OF THE
Resume Slide Processing After Interruption
1. Confirm that at least one cassette is loaded in the Imaging Station. Firmly
2. On the menu bar, click on the green GO button or pull down the slide pro-
3. The doors will lock. The display on the monitor indicates that processing
Cancel The Batch After Interrupting Slide Processing
1. If the system is to be shut down remove the slide cassettes. Run unpro-
2. Use the System pull down menu and select Shut Down. Follow shut down
Stat Slide Processing
A batch may be interrupted to run a single cassette of Stat slides. The operator
may resume or terminate the batch after running the stat slides, the same way
as interrupting a batch. The stat slides are placed in a cassette at position 10.
One to 25 slides can be run.
To run a stat slide, either click the yellow Stat button or select Run Stat Cassette
from the pull down menu. (Refer to Figure 3-26.)
3.24 Imager Duo Operator's Manual
I D
MAGER
close the sliding doors.
cessing menu and click on Start Slide Processing.
has begun. The STOP button on the menu bar is highlighted as available.
(Refer to Figure 3-25.)
Figure 3-25 Slide Processing Resumed
cessed cassettes in a later batch. Partially processed cassettes are considered
unprocessed and must be run in a later batch.
instructions described in Section I, Shutting Down the Image Processor.
UO