Inspection And Maintenance Work - Terex TL160 Operating Manual

7 Care and Maintenance
7.8

Inspection and maintenance work

7.8.1 Checks using the display
Attention
All checks must be carried out with the
machine standing on level ground and cooled
down.
The levels of engine oil, hydraulic oil and coolant can
be read on the check display.
Attention
With the diesel engine running, the level
indicator is without function!
Checking
• Switch on the ignition.
– The symbols "engine oil level" (38/71), "hydraulic
oil level" (38/72) and "coolant level" (38/73) light up
for approx. 3 sec on the display.
– If the level is insufficient, the relevant level
indicator lamp continues to light up.
• If required, top up the missing fluid.
7.8.2 Engine oil
7.8.2.1 Checking the engine oil level
• The oil level must be checked daily before start-up
with the machine standing on level ground.
• Observe the level indicator on the display of the
instrument panel.
• Insert the oil dipstick (39/1) until the stop. The
notches on the dipstick indicate the minimum and
maximum oil levels.
• Top up engine oil if necessary. Open the filler neck
(39/2) and add oil using a clean container. Close
the filler neck again.
Machine damage
due to excess oil.
Observe the permissible filling level of the
engine oil pan and avoid overfilling. Excess
oil may enter the crankcase breather and
lead to engine-speed control faults.
76/112
Fig. 38 Checks using the display
Fig. 39 Checking the engine oil level
Operating Manual 12.9.08 Version 1.0
P
-
+
1/2
0
71 72
4/4
73
TL160