Transport Of The Machine - Terex TL160 Operating Manual

6.2 Loading the machine by use of a
crane
Danger to life
due to exceeding the maximum weight-lifting
capacity.
• Ensure that the maximum lifting capacity
of the crane and the crane harness is not
exceeded.
To load the machine by use of a crane, the following
preparations are required:
• Empty the bucket and tip back.
• Move the lift frame to travel position.
• Apply the pin of the articulation lock (33/1 on the
articulation).
• Lower the work tool onto the ground.
• Switch off the engine.
• Dismount from the machine and close the doors.
• Attach the loader to the hoisting appliance at the
specified, marked points (Fig. 33) in the correct
manner.
6.3

Transport of the machine

To transport the machine onto a flat bed trailer,
railway goods wagon, etc. the following measures
must be taken:
• Empty the bucket and tilt back.
• Drive the machine onto the flat bed trailer, goods
wagon, etc., or lift by crane if required.
• Apply the pin of the articulation lock (34/1 on the
articulation).
• Lower the work tool onto the ground.
• Switch off the engine.
• Dismount from the machine and close the doors.
• Attach the machine at the points illustrated
(Fig. 34) in the correct manner.
Danger to life
due to disregarding the total transport height.
• It is essential to observe the clearance
heights of tunnels, bridges, etc.
TL160
Recovery, Loading and Transporting
Fig. 33 Crane suspension
Fig. 34 Lashing for transport
Operating Manual 12.9.08 Version 1.0
1
1
61/112
6