Terex TL160 Operating Manual page 94

7 Care and Maintenance
7.8.12 Hydraulic oil return filter
Machine damage
due to dirt reaching the uncovered hydraulic
oil tank.
• Before starting, clean all parts above the
tank.
Attention
• After a larger repair job, renew the filter
cartridge following the test run.
Changing the filter insert
• Switch off the engine.
• Open the breather (69/2).
• Remove the return filter cover (69/3).
• Pull out the filter bowl (70/2) along with the filter
insert (70/3).
• Remove the filter insert from the filter bowl by
turning and pulling at the same time.
• Clean the filter bowl using appropriate detergents.
• Ensure that the O-rings (70/4-6) are in perfect
condition and replace any damaged part.
• Insert a new filter element in the filter bowl.
• Re-insert the filter bowl along with the cartridge
into the hydraulic oil tank.
• Apply a light coat of grease to the cover seal.
• Install the return filter cover and tighten by hand.
• Check the tightness of the filter by means of a test
run.
94/112
3
L864-723
Fig. 69 Hydraulic oil tank
Fig. 70 Changing the filter insert of the return filter
Operating Manual 12.9.08 Version 1.0
2
TL160