Inspection And Maintenance Work; Engine Oil - Terex TL80 Operating Instructions Manual

7 Maintenance and Care

7.9 Inspection and maintenance work

7.9.1 Engine oil

Checking the engine oil level
•
The oil level must be checked daily before
start-up with the machine standing on level
ground.
•
The notches on the oil dipstick (35/1) indicate
the min. and max. oil levels.
•
Top up engine oil if necessary. Unscrew the
closure cap (35/2) and pour in oil using a clean
container.
Changing the engine oil
Collect the waste oil, do not allow it to
seep into the ground.
Dispose of according to regulations!
•
Run the engine until it reaches operating
temperature, engine oil temperature approx.
80 °C.
•
Park the machine on level ground.
•
Stop the engine.
•
Remove the cover from the bottom rear-end.
•
Place suitable drip pans under the opening
•
Screw the oil drain hose onto the oil-change
valve (35/3).
Danger of scalding when hot oil is
drained!
•
Remove the oil drain hose and screw the
protective cap onto the valve.
•
Close the service opening with the cover.
•
To change the engine oil filter (35/4), see
section 7.9.2.
•
Top up engine oil to the "MAX" mark on the oil
dipstick (35/1) using the filling hole (35/2).
•
Start the engine and run at low idle speed for
approx. 2 min.
•
Stop the engine.
76
•
Check oil level and refill oil (emptied cooler has
filled with oil).
•
Start the engine and run at low idle speed for
approx. 2 min.
•
Stop the engine.
•
Check the oil level and top up oil if required.
4
Fig. 35 Engine oil
6
2
5
1
3
L824-035
TL80