Terex TL160 Operating Manual page 30

3 Technical Specifications
3.9.2 Fuel, lubricant, and coolant specifications
Application Code
designation
according to
1
Bi
Engine –
Engine EO 1540 A
Hydraulic HYD 1040
system
BIO-E-HYD-
HEES
Axles, GO 90 LS
Wheel hubs
Lubricating MPG-A
points
Cooler
Tab. 11 Fuel, lubricant, and coolant specifications
1
In conformity with the regulation lubricants of the Main Association of the German Building Industry e. V.
30/112
Prescribed fuels, lubricants, and coolants
for Central Europe
Designation Specification, standards,
Diesel fuel
ASTM D975 1-D / 2-D
Engine oil
Hydraulic oil or
multi-grade
engine oil
Biodegradable Filling according to customer
hydraulic oil on specifications. Brand label on
synthetic ester
base
Machine damage
caused by non-mixable bio
oils.
• Do not mix bio oils from
Transmission oil SAE 85W-90LS
API-GL 5
Multi-purpose, K2K-30
lithium-soap
DIN 51825
based grease
Mixture of
Machine damage
water, additives
due to incorrect coolant
and glycol
and mix proportions.
Observe the information on
the cooling system given in
the engine manufacturer's
Operating and
Maintenance Manual.
Operating Manual 12.9.08 Version 1.0
Quality
EN 590
SAE 15W-40
API CF4
ACEA E3 or E2
HVLP 46
or
SAE 10W-40
machine.
different manufacturers.
Remarks
Attention
Before using RME fuels
(rape oil methyl ester), it is
essential to consult your
responsible Terex dealer
for further details.
See also engine manufacturer's
Operating Manual.
The following viscosity limit values
must be observed (according to
ASTM 445):
2
at 100 °C min. 8 mm / (cSt)
s
at –10 °C approx. 1500 mm
The same viscosity specifications
apply as for mineral hydraulic oils.
Attention
When changing from
mineral to biodegradable
hydraulic oils, the tank and
hydraulic system must be
completely drained,
cleaned and flushed.
For further details before
changing oils, please
consult your responsible
Terex dealer.
Alternative recommendations
SAE 90LS
SAE 80W-90LS
The antifreeze is factory-set to
approx. -25 °C.
2
/ (cSt)
s
TL160