Terex TL160 Operating Manual page 57

Procedure for changing work attachments with
hydraulic quick-attach system (option)
• Lower the work attachment onto the ground and
position so that it cannot tilt.
• Switch off the diesel engine.
• Switch on the ignition.
• Operate the push-button switches (27/5) for pres-
sure relief.
• In case of hydraulically controlled additional tools:
Release the hydraulic connections on both distrib-
utor blocks.
• Ball valve in position "Unlock quick-attach system"
(Fig. 28).
• Start the diesel engine.
• Unlock the quick-attach system (27/5) and move
out of the work attachment.
• Take up new work attachment and lock by press-
ing the push-button switch (27/5).
Danger to life
due to incorrectly fastened work attachments.
• Perform a visual check to ensure that the
quick-attach system is correctly locked.
• Switch off the diesel engine.
• Switch on the ignition.
• Operate the push-button switches (27/5) for pres-
sure relief.
• Ball valve in position "Quick-mount hitch locked"
(Fig. 28).
• Connect the hydraulically operated work attach-
ment to the connection of the additional control cir-
cuit.
Machine damage
due to additional control circuit which has not
been switched off.
• The additional control circuit (27/53) must
be switched off unless a hydraulically op-
erated additional attachment is connected.
TL160
Fig. 27 Operating the quick-attach system
Fig. 28 Releasing and locking the hydraulic quick-attach
system
Operating Manual 12.9.08 Version 1.0
Working Operation
P
12 Km/h
- +
00014,0 h
1/2
0 4/4
5
5
53
P
L864-504
57/112