Removing Tall Crop Feed Plates; Removing Tall Crop Feed Plates: Under Driven Deflector - MacDon R85 Operator's Manual

IMPORTANT:
Depending on disc (B) rotation, feed plate (A) should be
located so that when holes are aligned, the leading edge
of the feed plate is further from the accelerator (B) than
the trailing edge.
6. Install the deflector. Refer to
Deflector, page 143.

6.10.2 Removing Tall Crop Feed Plates

Follow these steps to remove the tall crop feed plates:
DANGER
Stop engine and remove key from ignition before leaving operator's seat for any reason. A child or even a
pet could engage an idling machine.
1. Lower header to the ground, shut off engine, and
remove key from ignition.
2. Open cutterbar doors. Refer to
page 33.
CAUTION
Exercise caution when working around the blades.
Blades are sharp and can cause serious injury. Wear
gloves when handling blades.
3. Place a block of wood between discs to prevent
deflector from turning.
Removing Tall Crop Feed Plates: Under Driven Deflector
1. Remove the deflector. Refer to
Deflector, page 141.
169457
OPERATING THE HEADER
Installing the Driveline
5.5 Cutterbar Doors,
Removing the Driven
84
Figure 6.27: LH End Top View Shown
Figure 6.28: Cutterbar Doors
Revision G