Removing Tall Crop Feed Plates - MacDon R85 Operator's Manual

1. Locate the feed plates. Refer to
Tall Crop Feed Plates from Storage, page
2. Lower the header fully.
3. Stop the engine and remove the key.
4. Open the cutterbar door(s). Refer to
Doors, page 33.
5. Install feed plate (A) on the disc.
IMPORTANT:
Depending on disc (B) rotation, the feed plate (A)
should be located so that when holes are aligned,
the leading edge of the feed plate is farther from the
accelerator (B) than the trailing edge.
6. Install the deflector. Refer to
Deflector, page 151.

4.11.2 Removing Tall Crop Feed Plates

Follow these steps to remove the tall crop feed plates:
DANGER
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove
the key from the ignition before leaving the operator's seat for any reason.
214014
OPERATING THE HEADER
4.11.1 Removing the
102.
3.5 Cutterbar
Installing the Driveline
104
Figure 4.28: Left End Shown
Figure 4.29: Left End Top View Shown
Revision B