Check Ap300 Led Activity - Meru Networks AP300 Installation Manual

3. Locate the bracket mounting clip holes on the mounting bracket (see
the bracket perpendicular to the box hanger; the other mounts the bracket parallel to the box
hanger.
4. Attach the U-joint of the clip to the T-bar and snap in place (see
Figure 12: Attaching the Mounting Bracket to the Box Hanger
.
5. Pass the long end clip through the large center hole to the underside of the mounting bracket clip
and then attach the bracket to the clip using the supplied screw (see
6. Hold the AP300 next to the mounting bracket to estimate the height of the T-bar box hanger to
provide enough clearance for the external antennas, which should be pointing down.
7. Adjust the height of the box hanger using the height adjusting screws (see
8. Clip the box hanger T-rail clips to the ceiling rails, making sure they are securely attached.
9. Connect a drop wire to a building structural element and through the hole provided in the bracket
mounting clip. The U.S. National Electrical Safety Code requires this additional support.
10. Connect the posts of the AP300 to the three keyholes of the mounting bracket and slide into the
keyhole, ensuring the locking detent is engaged. You will hear a click.
11. For each antenna, loosen the knurled ring at the base of the antenna (see
antenna down, then retighten the ring.
12. Connect one end of the PoE Ethernet cable to the Ethernet connector, shown in
Note:
13. Check that the AP300 is operating correctly before replacing the ceiling tile to the ceiling. Verify
correct operating using the LEDs, as shown in
© 2009 Meru Networks, Inc.Installing the AP300
For the AP201 and AP208 access points, use a shielded Cat 5e (or greater)
Ethernet cable in order to comply with international electromagnetic
emissions limits.
Figure
Check AP300 LED Activity.
Install the AP300
Figure 11). One hole attaches
12).
Figure 12 for orientation).
Figure 10).
Figure 8), point the
Figure 11.
19