Lldp Management Address List; Lldp Basic Tlvs Settings - D-Link DGS-1250 Series Reference Manual

DGS-1250 Series Gigabit Ethernet Smart Managed Switch Web UI Reference Guide
Parameter
Admin State
IP Subtype
Action
Address
Click the Apply button to accept the changes made.
NOTE: The IPv4 or IPv6 address entered here should be an existing LLDP management IP address.

LLDP Management Address List

This window is used to view the LLDP management address list.
To view the following window, click L2 Features > LLDP > LLDP Management Address List, as shown below:
The fields that can be configured are described below:
Parameter
Subtype
Click the Find button to locate a specific entry based on the selection made.

LLDP Basic TLVs Settings

The Type-Length-Value (TLV) field allows specific information to be sent within LLDP packets. This window is used to
configure basic TLV settings. An active LLDP port on the Switch always includes mandatory data in its outbound
advertisements. There are four optional data types that can be configured to exclude one or more of these data types
from outbound LLDP advertisements. The mandatory data type includes four basic types of TLVs: end of LLDPDU
TLV, chassis ID TLV, port ID TLV, and TTL TLV. The mandatory data types cannot be disabled. There are also four
Description
Select the local LLDP agent and allow it to send and receive LLDP frames on the
port. Options to choose from are TX, RX, TX and RX, and Disabled.
• TX - The local LLDP agent can only transmit LLDP frames.
• RX - The local LLDP agent can only receive LLDP frames.
• TX and RX - The local LLDP agent can both transmit and receive LLDP
frames.
• Disabled - The local LLDP agent can neither transmit nor receive LLDP
frames.
The default value is TX and RX.
Select the type of the IP address information to be sent. Options to choose from
are Default, IPv4, and IPv6.
Select the action that will be taken here. Options to choose from are Remove and
Add.
Enter the IP address that will be sent.
Figure 5-59 LLDP Management Address List Window
Description
Select the subtype. Options to choose from are All, IPv4 and IPv6. After selecting
the IPv4 option, enter the IPv4 address in the space provided. After selecting the
IPv6 option, enter the IPv6 address in the space provided.
114