About Your Projector; Remote Control - Panasonic PT-MZ10K Operating Instructions Manual

About your projector

Remote control

1 Power standby <v> button
Sets the projector to the state where the projector is turned
off (standby mode) when the <MAIN POWER> switch on the
projector is set to <ON> and in projection mode.
2 Power on <b> button
Sets the projector to projection mode when the <MAIN
POWER> switch on the projector is set to <ON> and the power
is turned off (standby mode).
3 Remote control indicator
Blinks if any button in the remote control is pressed.
4 Lens buttons (<FOCUS>, <ZOOM>, <SHIFT>)
Adjusts the focus, zoom, and lens shift. (x page 67)
5 <MENU> button/<ENTER> button/asqw buttons
Used to navigate through the menu screen. (x page 76)
asqw buttons are also used to enter the password in
[SECURITY] or enter characters.
6 <ON SCREEN> button
Switches the on-screen display function on (display) or off
(hide). (x page 72)
7 Input selection buttons (<RGB1/2>, <DIGITAL LINK>,
<DVI-D>, <SDI>, <HDMI>)
Switches the input signal to project. (x page 66)
The <VIDEO> button is not used with this projector.
8 <FUNCTION> button
Assigns a frequently used operation as a shortcut button.
(x page 73)
When the <FUNCTION> button is held down, the [FUNCTION
BUTTON] screen is displayed. (x page 142)
Attention
f Do not drop the remote control.
f Avoid contact with liquids or moisture.
f Do not attempt to modify or disassemble the remote control.
f Observe the following instructions that are indicated on the caution label at the back of the remote control:
g Do not use old battery with new one.
g Do not use batteries other than the type specified.
Chapter 1 Preparation — About your projector
Front
1
2
3
4
5 11
6
12
7
13
8
14
9
15
10
Top
Bottom
17
9 Number (<0> - <9>) buttons
Used for entering an ID number or a password in a multiple
projector environment.
10 <AUTO SETUP> button
Automatically adjusts the image display position and signal level
while projecting the image.
[PROGRESS] is displayed while in automatic adjustment.
(x page 73)
11 <SHUTTER> button
Used to temporarily turn off the image. (x page 72)
12 <TEST PATTERN> button
Displays the test pattern. (x page 73)
13 <STATUS> button
Displays the projector information.
14 <DEFAULT> button
Resets the setting of the displayed sub-menu to the factory
default. (x page 77)
15 <ID SET> button
Sets the ID number of the remote control in a multiple projector
environment. (x page 32)
16 Remote control signal transmitter
17 Remote control wired terminal
This is a terminal used to connect to the projector via a cable
when the remote control is used as a wired remote control.
(x page 32)
16
ENGLISH - 27