Using The Data Cloning Function; Copying The Data To Another Projector Via Lan - Panasonic PT-MZ10K Operating Instructions Manual

Using the data cloning function

Perform the operation of the data cloning function. Data such as the settings and adjustment values of the
projector can be copied to multiple projectors via LAN.
r Data that cannot be copied
The following settings cannot be copied. Set these in each projector.
f The [DISPLAY OPTION] menu → [UNIFORMITY]
f The [PROJECTOR SETUP] menu → [PROJECTOR ID]
f The [PROJECTOR SETUP] menu → [DATE AND TIME] → [ADJUST CLOCK]
f The [PROJECTOR SETUP] menu → [DATA CLONING] → [WRITE PROTECT]
f The [SECURITY] menu → [SECURITY PASSWORD]
f The [NETWORK] menu → [NETWORK SETUP]
f Security password
f Control device password
f Password set in "[Change password] page" (x page 184) of the web control screen
f Information of the CRT key and the self-signed certificate generated in "[Https set up] page" (x page 175) of
the web control screen, information of the installed server certificate
f "[E-mail set up] page" (x page 181) in the web control screen
f "[Authentication set up] page" (x page 182) in the web control screen
f "[Crestron Connected(TM)] page" (x page 186) in the web control screen
Note
f The data cloning function will not operate when the models of the projectors are different. For example, data of PT-MZ10K can be copied to
other PT-MZ10K projectors, but it cannot be copied to PT-MZ16K. Data cloning is limited to the same model.

Copying the data to another projector via LAN

Make the following settings on the projector of the copy destination in advance. For details, refer to "Setting
[WRITE PROTECT]" (x page 198).
f The [PROJECTOR SETUP] menu → [DATA CLONING] → [WRITE PROTECT] → [OFF]
1) Connect all projectors to the hub using LAN cables. (x page 163)
2) Turn on all the projectors.
3) Press as to select [DATA CLONING] on the copy source projector.
4) Press the <ENTER> button.
f The [SECURITY PASSWORD] screen is displayed.
5) Enter a security password and press the <ENTER> button.
f The [DATA CLONING] screen is displayed.
6) Press as to select [SELECT PROJECTOR].
7) Press the <ENTER> button.
f The projectors in the same subnet are displayed as a list.
8) Press as to select the copy destination projector.
9) Press the <ENTER> button.
f To select multiple projectors, repeat Steps 8) to 9).
10) Press the <DEFAULT> button on the remote control.
f The confirmation screen is displayed.
11) Press qw to select [OK], and press the <ENTER> button.
f Copy of the data between the projectors is started.
Once the copy is completed, results are displayed as a list in the [DATA CLONING] screen.
Meanings of the marks displayed in the list are as follows.
g Green: Data copy has succeeded.
Chapter 5 Operations — Using the data cloning function
ENGLISH - 197