Using The Automatic Setup Function; Using The Function Button; Displaying Internal Test Pattern - Panasonic PT-MZ10K Operating Instructions Manual

Chapter 3 Basic Operations — Operating with the remote control

Using the automatic setup function

The image position and signal level when the DVI-D/HDMI signal is input, or the resolution, clock phase, image
position, and signal level when the analog RGB signal is input can be adjusted automatically. (Analog RGB signal
is a signal structured with dots just like the computer signal.)
It is recommended to input an image with bright white borders at the edges and high-contrast black and white
characters when executing the automatic setup. Avoid using images that include halftones or gradation, such as
photographs and computer graphics.
button
1) Press the <AUTO SETUP> button.
f [COMPLETE] is displayed when it has completed without any problem.
Note
f The clock phase may shift even if it has completed without any incident. In such a case, adjust the [POSITION] menu → [CLOCK PHASE]
(x page 90).
f If an image with blurred edges or a dark image is input, [INCOMPLETE] may appear or adjustment may not be performed properly even
when [COMPLETE] appears. In such a case, adjust the following settings.
g [ADVANCED MENU] menu → [INPUT RESOLUTION] (x page 97)
g [POSITION] menu → [CLOCK PHASE] (x page 90)
g [POSITION] menu → [SHIFT] (x page 88)
f Adjust special signals according to the [DISPLAY OPTION] menu → [AUTO SETUP] (x page 103).
f Automatic adjustment may not be possible depending on the computer model.
f Image may be disrupted for a few seconds during execution of the automatic setup, but this is not a malfunction.
f Adjustment is required for each input signal.
f Automatic setup can be canceled by pressing the <MENU> button while the automatic setup is being executed.
f Even if a signal possible to perform the automatic setup is being input, it may not be able to adjust correctly if the automatic setup function is
executed while the moving image is being input. [INCOMPLETE] may be displayed, or the adjustment may not be completed correctly even
if [COMPLETE] is displayed.

Using the function button

By assigning the following functions to the <FUNCTION> button, it can be used as a simplified shortcut button.
[SUB MEMORY], [SYSTEM SELECTOR], [SYSTEM DAYLIGHT VIEW], [FREEZE], [WAVEFORM MONITOR],
[LENS MEMORY LOAD], [ASPECT], [PROJECTION METHOD], [GEOMETRY], [OSD POSITION]
button
1) Press the <FUNCTION> button.
Note
f Assignment of the function is performed from the [PROJECTOR SETUP] menu → [FUNCTION BUTTON] (x page 142).

Displaying internal test pattern

The projector has nine types of internal test patterns to check the condition of the projector. To display test
patterns, perform the following steps.
button
1) Press the <TEST PATTERN> button.
2) Press qw to select the test pattern.
Note
f Test patterns can also be displayed using the menu operation. Refer to "[TEST PATTERN] menu" (x page 150) for details.
f Settings of position, size, and other factors will not be reflected in test patterns. Make sure to display the input signal before performing
various adjustments.
ENGLISH - 73