Attaching/Removing The Projection Lens (Optional); Attaching The Projection Lens - Panasonic PT-MZ10K Operating Instructions Manual

Chapter 2 Getting Started — Attaching/removing the projection lens (optional)

Attaching/removing the projection lens (optional)

Move the lens position to the home position before replacing or removing the projection lens. (x page 70)
Attention
f Do not attach or remove the projection lens while the projector is installed to a ceiling or in a high location.
f Replace the projection lens after turning off the projector.
f Do not touch the electric contacts of the projection lens. Dust or dirt may cause poor contact.
f Do not touch the surface of the projection lens with your bare hands.
f Do not turn the gear of the projection lens by hand. Doing so may damage the motor.
f Before attaching the projection lens, remove the lens cover attached to the projection lens.
f Panasonic takes no responsibility for any damage or malfunction of the product resulting from the use of projection lenses which are not
manufactured by Panasonic. Be sure to use the specified projection lenses.
Note
f For the adjustment procedure of the focus, zoom, and lens shift after attaching the projector lens, refer to "Adjusting the focus, zoom, and
lens shift" (x page 67).
f For the adjustment procedure of the focus balance in the center and periphery of the projected image when the Zoom Lens (Model No.:
ET-EMW200, ET-EMW300, ET-EMW400, ET-EMW500) is used, refer to "Adjusting the focus balance" (x page 68).

Attaching the projection lens

Attach the projection lens using the following procedure.
Start from Step 2) when the dustproof sponge is already removed.
f Tool used: Ball point hex driver (diagonal 2.5 mm (3/32"))
Dustproof sponge
Fig. 1
Mark on the projection lens (red)
Protruding mark on the projector
Fig. 4
1) Remove the dustproof sponge. (Fig. 1)
2) Remove the top slide cover. (Fig. 2)
f Slide the top slide cover until the top slide cover attachment line is visible.
Once the top slide cover attachment line is visible, remove by lifting.
3) Confirm that the lens lock lever is positioned at the Unlock side. (Fig. 3)
f If the lens lock lever is at the Lock side (Fig. 5), pinch the lens lock lever and turn to the Unlock side. (Fig.
3)
Top slide cover
Fig. 2
Lens lock lever
Unlock Lock
Fig. 5
Top slide cover attachment line
Lens lock lever
Unlock
Lens fixing screw
Lock
Fig. 3
Screw hole
Fig. 6
ENGLISH - 43