Control Commands Via Lan - Panasonic PT-MZ10K Operating Instructions Manual

r COLOR, TINT
Performance
No operation
Factory default setting
-31
...
0
...
+31
No operation
r RASTER PATTERN
Performance
No operation
OFF
WHITE
YELLOW
CYAN
GREEN
MAGENTA
RED
BLUE
BLACK
USER LOGO
No operation
r ENABLE/DISABLE
Operation for all channels is not accepted when set to "Disable".
Performance
Disable
Enable
Note
f If the projector is operated using the remote control or the control panel, or by the control command while controlling the projector using the
Art-Net function, the setting of the DMX controller or computer application may be different from the projector status. To reflect the controls
of all channels to the projector, set "ENABLE/DISABLE" of channel 11 to "Disable" and then back to "Enable".
f To create and register the USER LOGO image, use "Logo Transfer Software".
The software can be downloaded from the Panasonic website (https://panasonic.net/cns/projector/).

Control commands via LAN

The projector can be controlled via the <DIGITAL LINK> terminal or the <LAN> terminal by using the control
command format via the <SERIAL/MULTI PROJECTOR SYNC IN> terminal.
For examples of the available commands, refer to "Control command" (x page 229).
When web control administrator rights password is set (Protect mode)
Connecting
1) Obtain the IP address and port number (Initial set value = 1024) of the projector and request a
connection to the projector.
f You can obtain both the IP address and the port number from the menu screen of the projector.
IP address
Port number
222 - ENGLISH
Chapter 7 Appendix — Technical information
Obtain from the [NETWORK] menu → [NETWORK STATUS].
Obtain from the [NETWORK] menu → [NETWORK CONTROL] → [COMMAND PORT].
Parameter
0-31
32-63
64-65
...
128-129
...
190-191
192-255
Parameter
0-15
16-31
32-47
48-63
64-79
80-95
96-111
112-127
128-143
144-159
160-175
176-255
Parameter
0-127
128-255
Default value
0
Default value
0
Default value
0