[Multi Projector Sync] - Panasonic PT-MZ10K Operating Instructions Manual

8) Press asqw to select [COMMAND].
9) Press the <ENTER> button.
f The [COMMAND] detailed screen is displayed.
10) Press as to select a [COMMAND].
f For [COMMAND] which requires detailed settings, the items of the detailed settings will switch each time
you press qw.
f When [INPUT] is selected, press the <ENTER> button, and then press asqw to select the input to be
set.
[COMMAND]
[POWER ON]
[STANDBY]
[QUICK STARTUP]
[SHUTTER]
[INPUT]
[OPERATING MODE]
*1 When the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G) is connected to the projector, its input
name is automatically reflected from [INPUT1] to [INPUT10]. When an item that does not reflect the input name is selected, it will be disabled.
*2 If you change the settings while using the projector, the duration until the luminance decreases by half may shorten or the luminance may
decrease.
11) Press the <ENTER> button.
f The command is fixed and n is displayed at the left of the selected command.
f After the command is fixed, press the <MENU> button to close the detailed setting screen.
12) Press asqw to select [STORE], and press the <ENTER> button.
Note
f To delete a command that has been already set, press the <DEFAULT> button on the remote control while the screen in Step 5) is
displayed, or select [DELETE] at the screen in Step 6) and press the <ENTER> button.
f If multiple commands have been set for the same time, they are executed in chronological order starting from the smallest command
number.
f The operating time will be the local time. (x page 136)
f If an operation is executed with the remote control or control panel of the projector or with a control command before the command set in
[SCHEDULE] is executed, the command set with the schedule function may not be executed.

[MULTI PROJECTOR SYNC]

Set the contrast synchronization function and the shutter synchronization function.
The contrast synchronization function is a function to display a combined screen with a balanced contrast by
sharing the brightness level of the video signal input to each projector when a multi-display is constructed
by combining the projected image of multiple projectors. The shutter synchronization function is a function to
synchronize the shutter operation of the specified projector to other projectors, and the effect using the shutter
function including the fade out/fade in operation can be synchronized.
138 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Detailed settings of
[COMMAND]
―
―
[ON]
[OFF]
[OPEN]
[CLOSE]
[HDMI]
[DVI-D]
[SDI]
[RGB]
[DIGITAL LINK]
[INPUT1] - [INPUT10]
[NORMAL]
[QUIET]
*2
[USER1]
[USER2]
[USER3]
Switches on the projector.
Enters standby.
Enables the function of the [PROJECTOR SETUP] menu →
[QUICK STARTUP].
Disables the function of the [PROJECTOR SETUP] menu →
[QUICK STARTUP].
Disables the shutter function (shutter: opened).
Enables the shutter function (shutter: closed).
Switches the input to HDMI.
Switches the input to DVI-D.
Switches the input to SDI.
Switches the input to RGB.
Switches the input to DIGITAL LINK.
Switches the input to DIGITAL LINK, and switches the input of the
*1
Panasonic twisted-pair-cable transmitter to the specified input.
Prioritizes brightness.
Operates the projector with low noise although the brightness
decreases compared to [NORMAL].
Controls the power with the setting set in [USER1].
Controls the power with the setting set in [USER2].
Controls the power with the setting set in [USER3].
Description