Remote 1 In> Terminal; Control Device Password - Panasonic PT-MZ10K Operating Instructions Manual

<REMOTE 1 IN> terminal
It is possible to control the projector remotely (by contact control) from a control board located away from the
projector where remote control signals cannot reach.
Use the <REMOTE 1 IN> terminal on the connecting terminals of the projector to connect to the control board.
Installation locations in meeting rooms, etc.
Pin assignments and signal names
D-Sub 9-pin
Outside view
(6) (9)
(1) (5)
Attention
f When controlling, make sure to short-circuit pins (1) and (9).
f When pins (1) and (9) are short-circuited, the following buttons on the control panel and the remote control are disabled. Commands for
RS-232C and network functions corresponding to these functions are also disabled.
g Power on <b> button, power standby <v> button, <SHUTTER> button
f When pins (1) and (9) are short-circuited, and then any pins from (3) to (7) and the pin (1) are short-circuited, the following buttons on the
control panel and the remote control are disabled. Commands for RS-232C and network functions corresponding to these functions are also
disabled.
g Power on <b> button, power supply standby <v> button, <RGB1/2> button, <DVI-D> button, <HDMI> button, <DIGITAL LINK> button,
<SDI> button, <SHUTTER> button
Note
f To change the settings of pins (2) to (8), set the [PROJECTOR SETUP] menu → [REMOTE1 MODE] to [USER]. (x page 142)

Control device password

To initialize your password, consult your distributor.
230 - ENGLISH
Chapter 7 Appendix — Technical information
Pin No.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
Remote control
Remote control/contact control
Standby
RGB
SDI
DVI-D
Remote control board in another location
Signal name Open (H)
GND ―
POWER OFF
HDMI Other
DVI-D Other
SDI Other
RGB Other
DIGITAL LINK Other
SHUTTER OFF
Controlled by remote
RST/SET
control
Contact control
Lit
Light source
DIGITAL LINK
HDMI
Short (L)
GND
ON
HDMI
DVI-D
SDI
RGB
DIGITAL LINK
ON
Controlled by external
contact