Panasonic PT-MZ10K Operating Instructions Manual page 198

g Red: Data copy has failed. Confirm the connection of the LAN cable and power status of the copy
destination projector.
f Data is copied to the copy destination projector in the standby mode.
If the copy destination projector is in the projection mode, the data cloning request message is displayed,
and then the copy destination projector automatically shifts to the standby mode to start copy of data.
12) Turn on the copy destination projector.
f The copied content is reflected to the projector.
Note
f The security password is the password set in the [SECURITY] menu → [SECURITY PASSWORD CHANGE].
Initial password of the factory default setting: awsqawsq
f The light source indicator <LIGHT>, the temperature indicator <TEMP>, and the filter indicator <FILTER> of the destination projector blink
while copying the data. Confirm the blinking of the indicators stops, and then turn on the power supply.
Setting [WRITE PROTECT]
Set if the copy of data using the data cloning function is permitted or not.
1) Press as to select [DATA CLONING] on the copy destination projector.
2) Press the <ENTER> button.
f The [SECURITY PASSWORD] screen is displayed.
3) Enter a security password and press the <ENTER> button.
f The [DATA CLONING] screen is displayed.
4) Press as to select [WRITE PROTECT].
5) Press qw to switch the item.
f The items will switch each time you press the button.
[OFF]
[ON]
Note
f The security password is the password set in the [SECURITY] menu → [SECURITY PASSWORD CHANGE].
Initial password of the factory default setting: awsqawsq
198 - ENGLISH
Chapter 5 Operations — Using the data cloning function
Permits operations of the data cloning function from another projector.
Does not permit the operations of the data cloning function from another projector.
f Data copy will not be possible when [ON] is set. When it is not necessary to copy data of another
projector, set to [ON] so that the data is not changed by mistake.