Panasonic PT-MZ10K Operating Instructions Manual page 30

18 NFC touch point
This is the touch point when using the near field communication
(NFC, Near Field Communication) function. A device such as a
smartphone equipped with the NFC function can be connected
to the projector by holding it near the touch point.
Attention
f Do not block the ventilation ports (intake and exhaust) of the projector.
The components may deteriorate faster if cooling inside the projector is inhibited.
Note
f The optional NFC Upgrade Kit (Model No.: ET-NUK10) can be used to enable the NFC function of the projector. Note that there are some
models that have the NFC function enabled from the time of factory shipment, and there are some countries or regions where the NFC
Upgrade Kit cannot be applied.
For the availability of the NFC function in the country or region where you purchased the product, visit the Panasonic website (https://
panasonic.net/cns/projector/) or consult your dealer.
f For the connection using the NFC function, use the application software "Smart Projector Control" which performs the setting and
adjustment of the projector. For details on the "Smart Projector Control", visit the Panasonic website (https://panasonic.net/cns/projector/).
r Control panel
1 Power on <b> button
Sets the projector to projection mode when the <MAIN
POWER> switch on the projector is set to <ON> and the power
is turned off (standby mode).
2 Power standby <v> button
Sets the projector to the state where the projector is turned
off (standby mode) when the <MAIN POWER> switch on the
projector is set to <ON> and in projection mode.
3 <MENU> button
Displays or hides the main menu. (x page 76)
Returns to the previous menu when a sub-menu is displayed.
If you press the <MENU> button on the control panel for at least
three seconds while the on-screen display is off (hidden), the
on-screen display is turned on.
4 <SHUTTER> button
Used to temporarily turn off the image. (x page 72)
30 - ENGLISH
Chapter 1 Preparation — About your projector
1
2
3
4
19 Burglar hook port
Attaches a burglar prevention cable, etc.
5
6
7
8
9
10
5 Information monitor
Displays various statuses and error information. (x page 189)
6 <INFO> button
Used to operate the information monitor. (x page 189)
7 <INPUT SELECT> button
Switches the input signal to project. (x page 66)
8 <ENTER> button
Determines and executes an item in the menu screen.
9 asqw selection buttons
Used to select an item in the menu screen, change the setting,
and adjust the level.
Also used to enter a password in [SECURITY] or enter
characters.
10 <LENS> button
Adjusts the focus, zoom, and lens shift.