Table of Contents
Advertisement
About your projector
Remote control
1
Power standby <v> button
Sets the projector to the state where the projector is turned off
(standby mode) when the <主电源> switch on the projector is
set to <开> and in projection mode.
2
Power on <b> button
Sets the projector to projection mode when the <主电源> switch
on the projector is set to <开> and the power is turned off
(standby mode).
3
Remote control indicator
Blinks if any button in the remote control is pressed.
4
Lens buttons (<聚焦>, <变焦>, <移位>)
Adjusts the focus, zoom, and lens shift. (x page 63)
5
<菜单> button/<执行> button/asqw buttons
Used to navigate through the menu screen. (x page 72)
asqw buttons are also used to enter the password in
[SECURITY] or enter characters.
6
<屏幕显示> button
Switches the on-screen display function on (display) or off
(hide). (x page 68)
7
Input selection buttons (<RGB1/2>, <DIGITAL LINK>,
<DVI-D>, <SDI>, <HDMI>)
Switches the input signal to project. (x page 62)
The <VIDEO> button is not used with this projector.
8
<功能> button
Assigns a frequently used operation as a shortcut button.
(x page 69)
When the <功能> button is held down, the [FUNCTION
BUTTON] screen is displayed. (x page 138)
Attention
f Do not drop the remote control.
f Avoid contact with liquids or moisture.
f Do not attempt to modify or disassemble the remote control.
f Observe the following instructions that are indicated on the caution label at the back of the remote control:
g Do not use old battery with new one.
g Do not use batteries other than the type specified.
Chapter 1 Preparation — About your projector
Front
1
2
3
4
5
11
6
12
7
13
8
14
9
15
10
Top
Bottom
17
9
Number (<0> - <9>) buttons
Used for entering an ID number or a password in a multiple
projector environment.
10 <自动设置> button
Automatically adjusts the image display position and signal level
while projecting the image.
[PROGRESS] is displayed while in automatic adjustment.
(x page 69)
11 <快门> button
Used to temporarily turn off the image. (x page 68)
12 <测试模式> button
Displays the test pattern. (x page 69)
13 <状态> button
Displays the projector information.
14 <默认> button
Resets the setting of the displayed sub-menu to the factory
default. (x page 73)
15 <ID 设定> button
Sets the ID number of the remote control in a multiple projector
environment. (x page 28)
16 Remote control signal transmitter
17 Remote control wired terminal
This is a terminal used to connect to the projector via a cable
when the remote control is used as a wired remote control.
(x page 28)
16
ENGLISH - 23
Advertisement
Table of Contents
