Switching On The Projector - Panasonic PT-MZ10K Operating Instructions Manual

Chapter 3 Basic Operations — Switching on/off the projector

Switching on the projector

Attach the projection lens before switching on the projector.
Remove the lens cover first.
3)
1) Connect the power cord to the projector.
2) Connect the power plug to an outlet.
3) Press the <ON> side of the <MAIN POWER> switch to turn on the power.
f The power indicator <ON (G)/STANDBY (R)> lights/blinks in red, and the projector enters the standby
mode.
4) Press the power on <b> button.
f The power indicator <ON (G)/STANDBY (R)> lights in green and the image is soon projected on the screen.
Note
f It will take longer to start the projection when the [PROJECTOR SETUP] menu → [STANDBY MODE] is set to [ECO] compared to the time
when it is set to [NORMAL].
f Projection will start in approximately one second when the [PROJECTOR SETUP] menu → [QUICK STARTUP] is set to [ON] and if the
power is turned on within a specified time after going into the standby mode.
The specified time is the time set in the [PROJECTOR SETUP] menu → [QUICK STARTUP] → [VALID PERIOD].
f When the power is turned on or an input signal is switched, you may hear a high-frequency driving sound. This is not a malfunction.
f If the power was turned off during projection at the previous use by setting the <MAIN POWER> switch to <OFF> or by using the breaker
directly while projecting, the power indicator <ON (G)/STANDBY (R)> lights up in green and an image is projected after a while when the
power is turned on by setting the <MAIN POWER> switch to <ON> or by turning the breaker on with the power plug connected to the outlet.
This applies only when the [PROJECTOR SETUP] menu → [INITIAL STARTUP] is set to [LAST MEMORY].
56 - ENGLISH
2) 1)
4)
4)