[Remote1 Mode]; [Function Button] - Panasonic PT-MZ10K Operating Instructions Manual

7) Press as to select [RESPONSE(ID GROUP)].
8) Press qw to switch the item.
[ON]
[OFF]
Note
f When [INPUT SELECT] is set to [DIGITAL LINK], communication using that serial terminal is available only when the corresponding device
(such as the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G)) is connected to the <DIGITAL LINK>
terminal.
f When transferring logos via the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G), setting for "NO
SIGNAL SLEEP" of the DIGITAL LINK output supported device should be set to "OFF" to avoid interruption of communication.
f When [INPUT SELECT] is set to [DIGITAL LINK], communication speed for input is fixed to 9 600 bps and the parity is fixed to "NONE".

[REMOTE1 MODE]

Set the <REMOTE 1 IN> terminal.
1) Press as to select [REMOTE1 MODE].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[DEFAULT]
[USER]
f Proceed to Step 3) when [USER] is selected.
3) Press the <ENTER> button.
4) Press as to select one from [PIN2] to [PIN8], and press qw to switch the setting.

[FUNCTION BUTTON]

Set the function of the <FUNCTION> button on the remote control.
1) Press as to select [FUNCTION BUTTON].
2) Press the <ENTER> button.
f The [FUNCTION BUTTON] screen is displayed.
3) Press as to select a function.
[DISABLE]
[SUB MEMORY]
[SYSTEM SELECTOR]
[SYSTEM DAYLIGHT VIEW]
[FREEZE]
[WAVEFORM MONITOR]
[LENS MEMORY LOAD]
[ASPECT]
[PROJECTION METHOD]
[GEOMETRY]
[OSD POSITION]
4) Press the <ENTER> button.
142 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Returns the response when an ID is designated as GROUP.
Does not return the response when an ID is designated as GROUP.
Uses pin assignment of the <REMOTE 1 IN> terminal in standard setting. (x page 230)
Changes the setting of the <REMOTE 1 IN> terminal.
Disables the <FUNCTION> button.
Displays the sub memory list. (x page 153)
Switches the [SYSTEM SELECTOR] setting according to the input signal of the image being
projected.
f When the input signal is anything other than the SDI input
The [PICTURE] menu → [SYSTEM SELECTOR] (x page 86)
f When the input signal is the SDI input
The [DISPLAY OPTION] menu → [SDI IN] → [SYSTEM SELECTOR] (x page 110)
Switches the [SYSTEM DAYLIGHT VIEW] setting. (x page 84)
Freezes the image temporarily. (x page 120)
Displays the waveform of the input signal. (x page 120)
Loads the registered lens memory. (x page 124)
Switches the aspect ratio of the image. (x page 88)
Switches the [PROJECTION METHOD] setting. (x page 123)
Switches the [GEOMETRY] setting. (x page 90)
Switches the [OSD POSITION] setting. (x page 113)