Light Source/Temperature/Filter Indicators; When An Indicator Lights Up - Panasonic PT-MZ10K Operating Instructions Manual

Chapter 6 Maintenance — Light source/temperature/filter indicators

Light source/temperature/filter indicators

When an indicator lights up

If a problem occurs inside the projector, the slight source indicator <LIGHT>/temperature indicator <TEMP>/filter
indicator <FILTER> will inform you by lighting or blinking. Check the status of the indicators and take following
measures.
Attention
f When switching off the projector to deal with problems, make sure to follow the procedure in "Switching off the projector" (x page 65).
Light source indicator <LIGHT>
Indicator status
Some of the elements of the light
Lighting in red source are defective and the light
output has decreased.
Blinking in red The light source is turned off since the
(1 time) projection lens cannot be detected.
Blinking in red
The light source does not light up,
(2 times)
or the light source turns off while the
Blinking in red
projector is in use.
(3 times)
Note
f If the light source indicator <LIGHT> is still lit or blinking after taking the measures, set the <MAIN POWER> switch to <OFF>, and ask your
dealer for repairs.
206 - ENGLISH
Status
f Turn the <MAIN POWER> switch to <OFF> (x page 65), and turn on the
power again.
f Turn off the power and mount the projection lens again. (x page 43)
f Turn the <MAIN POWER> switch to <OFF> (x page 65), and turn on the
power again.
f Turn the <MAIN POWER> switch to <OFF> (x page 65), and turn on the
power again.
Light source indicator <LIGHT>
Temperature indicator <TEMP>
Filter indicator <FILTER>
Solution