When The Initial Setting Screen Is Displayed - Panasonic PT-MZ10K Operating Instructions Manual

Chapter 3 Basic Operations — Switching on/off the projector

When the initial setting screen is displayed

When the projector is switched on for the first time after purchase, or when the [PROJECTOR SETUP] menu →
[INITIALIZE] → [FACTORY RESET] is executed, the focus adjustment screen is displayed after projection starts,
and then the [INITIAL SETTING] screen is displayed. Set them according to the circumstances.
In other occasions, you can change the settings by menu operations.
If you press the <MENU> button while the [INITIAL SETTING] screen is displayed, you can go back to the
previous screen.
Focus adjustment
Adjust the focus to display the menu screen clearly.
Adjustment of the zoom and shift may also be necessary.
Refer to "Adjusting the focus, zoom, and lens shift" (x page 67) for details.
1) Press asqw to adjust the focus.
2) Press the <MENU> button to proceed to the initial setting.
Note
f Adjust the periphery focus when the Zoom Lens (Model No.: ET-EMW200, ET-EMW300, ET-EMW400, ET-EMW500) is used.
Refer to "Adjusting the focus balance" (x page 68) for details.
f If the focus adjustment or periphery focus adjustment is executed while the [PROJECTOR SETUP] menu → [LENS] → [ACTIVE FOCUS
OPTIMIZER] → [ACTIVE FOCUS] is set to [ON], the operation of the temperature detection correction of the active focus optimizer function
will stop.
Initial setting (display language)
Select the language to show on the screen.
After completed the initial setting, you can change the display language from the [DISPLAY LANGUAGE] menu.
1) Press as to select the display language.
2) Press the <ENTER> button to proceed to the initial setting.
LENS
FOCUS
ADJUST
INITIAL SETTING
Please select DISPLAY LANGUAGE.
SELECT
SET
ENTER
1/7
ENGLISH - 57