[Light Output]; [Standby Mode] - Panasonic PT-MZ10K Operating Instructions Manual

r PT-MZ10K

[LIGHT OUTPUT] (%)

100.0
80.0
60.0
40.0
*1 Estimated runtime is the time until the brightness decreases to approximately half of the time of delivery when the projector is used with the
[PICTURE] menu → [DYNAMIC CONTRAST] set to [3] and under environment of 0.15 mg/m
Note
f The runtime may be shorter than the estimation due to the influence of characteristics of each light source, conditions of use, installation
environment, etc.
f If the runtime exceeds 20 000 hours, replacement of the components inside the projector may be required. Consult your dealer for details.
[LIGHT OUTPUT]
Adjust the brightness of light source.
The setting is reflected when it is already set with "Initial setting (operation setting)" (x page 58) in the [INITIAL
SETTING] screen or with the [PROJECTOR SETUP] menu → [OPERATION SETTING]. The [LIGHT OUTPUT]
setting is synchronized with the [PROJECTOR SETUP] menu → [OPERATION SETTING] → [LIGHT OUTPUT].
The most recent setting is reflected in both items.
1) Press as to select [LIGHT OUTPUT].
2) Press qw to adjust.
Operation
Press w.
Press q.
Note
f [LIGHT OUTPUT] can be adjusted individually for each setting item of [OPERATING MODE].
f The uniformity of the brightness between multiple screens can be maintained by adjusting [LIGHT OUTPUT] for each projector when
structuring a multi-display screen by combining the projected images from multiple projectors.

[STANDBY MODE]

Set the power consumption during standby.
1) Press as to select [STANDBY MODE].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[NORMAL]
[ECO]
Note
f When [ECO] is set, the network function, the <SERIAL/MULTI PROJECTOR SYNC OUT> terminal, and some RS-232C commands become
inoperable during standby. When [NORMAL] is set, the network function and the <SERIAL/MULTI PROJECTOR SYNC OUT> terminal can
be used during standby.
Chapter 4 Settings — [PROJECTOR SETUP] menu
Brightness (lm)
100.0
90.0
80.0
70.0
60.0
50.0
40.0
30.0
20 000 21 000 22 000
Estimated runtime (hours)
Brightness
The screen becomes brighter.
The screen becomes darker.
Select this item when using the network function during standby.
Select this item to reduce power consumption during standby.
10 000
8 000
6 000
4 000
dust.
3
10 000
4 000
23 000 24 000 25 000
Adjustment
Runtime (estimate)
The runtime becomes shorter.
The runtime becomes longer.
Estimated runtime (hours)
*1
20 000
21 500
23 000
25 000
Range of adjustment
8.0 % - 100.0 %
ENGLISH - 131