Remote 2 In> Terminal - Panasonic PT-REZ80 Operating Instructions Manual

r Lens control command
Command Sub command
VXX LNSI2
VXX LNSI3
VXX LNSI4
VXX LNSIG
VXX LNSI5
<REMOTE 2 IN> terminal
It is possible to control the projector remotely (by contact control) from a control board located away from the
projector where remote control signals cannot reach.
Use the <REMOTE 2 IN> terminal on the connecting terminals of the projector to connect to the control board.
Installation locations in meeting rooms, etc.
Pin assignments and signal names
Outside view
(6) (9)
(1) (5)
Attention
f When controlling, make sure to short-circuit pins (1) and (9).
f When pins (1) and (9) are short-circuited, the following buttons on the control panel and the remote control are disabled. Commands for
RS-232C and network functions corresponding to these functions are also disabled.
g <POWER ON> button, <STANDBY> button, <SHUTTER> button
f When pins (1) and (9) are short-circuited, and then any pins from (3) to (7) and the pin (1) are short-circuited, the following buttons on the
control panel and the remote control are disabled. Commands for RS-232C and network functions corresponding to these functions are also
disabled.
g <POWER ON> button, <STANDBY> button, <HDMI1> button, <HDMI2> button, <HDMI 1/2> button, <SLOT> button,
<INPUT MENU> button, <SHUTTER> button
Note
f To change the settings of pins (2) to (8), set [REMOTE2 MODE] to [USER]. (x page 181)
288 - ENGLISH
Chapter 7 Appendix — Technical information
Details
Lens H shift
Lens V shift
+00000 = Fine adjustment 1+, +00001 = Fine adjustment 1-, +00100
Lens focus = Fine adjustment 2+, +00101 = Fine adjustment 2-, +00200 = Coarse
adjustment+, +00201 = Coarse adjustment-
Lens periphery focus
Lens zoom
Pin No.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
Remote control
Remote control/contact control
Standby
HDMI1
DisplayPort
Remote control board in another location
Signal name
GND
POWER
HDMI1
HDMI2
DisplayPort
None
None
SHUTTER
Controlled by remote
ENABLE / DISABLE
Remark
Contact control
Lit
Light source
HDMI2
SLOT
Open (H) Short (L)
― GND
OFF ON
Other HDMI1
Other HDMI2
Other DisplayPort
― ―
― ―
OFF ON
Controlled by external
control contact