Table of Contents
Advertisement
Connecting the Power Cord
Follow these guidelines when connecting your MultiPASS C50 to a power source:
Connect the power cord as follows:
1. Plug the supplied power cord into the power receptacle on the MultiPASS
2-18
Setting Up Your MultiPASS C50
The MultiPASS C50 is intended for domestic use only and requires 200-240 V
AC. Do not use it outside the country where it was purchased.
Use only the power cord that came with the unit. Using a longer cord or
extension cord can cause the MultiPASS C50 to malfunction.
Unplug the unit only by pulling on the plug itself. Never pull on the cord.
Do not plug the MultiPASS C50 into an outlet shared with an appliance such
as an air conditioner, computer, electric typewriter, or copier. These devices
generate electrical noise, which can interfere with the MultiPASS C50's
operation.
Make sure nothing is laying on the power cord, and that the cord cannot be
walked on or tripped over.
Do not overload the electrical outlet. Make sure the total amperage used by
all the machines plugged into the outlet does not exceed the ampere rating of
the outlet's circuit breaker.
Make sure the operation panel of the MultiPASS C50 is properly closed, and
that there are no documents in this area.
C50.
Chapter 2
Advertisement
Table of Contents
