Table of Contents
Advertisement
2. Use the numeric buttons to dial the other party's fax number.
ABC
DEF
1
2
3
GHI
JKL
MNO
4
5
6
PQRS
TUV
WXYZ
7
8
9
0
3. Press START/COPY.
Chapter 4
Ex:
TEL=9p1503753798
Use one of the dialling methods described on page 4-7.
If you must first dial a digit to get an outside line (e.g. "9"), press the
(REDIAL)/PAUSE button to add a pause after that digit, as shown in the
example above.
The MultiPASS C50 then begins scanning the document into memory, and
dials the number:
TX
After a few seconds, the display shows the following messages:
TX/RX NO.
SCANNING
CALLING
TEL=9p1503753798
The display continues to show these displays while the fax is sending.
When the MultiPASS C50 finishes sending the fax, the display shows the
TRANSMITTING OK message:
TRANSMITTING OK
The transaction number (TX/RX NO.) is a unique number the MultiPASS
C50 assigns to the document you are sending or receiving, and is used to
identify the document in transaction reports.
If an error occurs during sending, the MultiPASS C50 will print out an error
report. If this happens, try sending the fax again. See "Faxing Problems" on
page 8-12 for details about errors.
0001
(Transaction number for the fax)
P.001
(Number of pages it has scanned)
(The number you dialled)
Sending Faxes
4-11
Advertisement
Table of Contents
