Attaching The Document Support - Canon MultiPASSTM C50 User Manual

Attaching the Document Support

The document support catches documents as they come out of the MultiPASS
C50 after being faxed or scanned. You can operate the MultiPASS C50 with or
without this support.
The ends of the metal support fit into the slots on the front of the MultiPASS
C50, as shown below. To install it, slightly squeeze the ends of the support toward
each other, insert them in the slots, and gently release them. Then slide the
support into the unit until it clicks in position.
When the support is installed, you can pull it out or push it in to suit the size of
the document.
2-12 Setting Up Your MultiPASS C50
When inserting the document support, make sure that it curves upwards, as
shown in the figures above.
If you do not wish to use the support, you can remove it completely.
Chapter 2