Table of Contents
Advertisement
Message
MEMORY FULL
MEMORY FULL
PLEASE WAIT
MEMORY USED nn%
NO ANSWER
NO TEL #
NOT AVAILABLE
PLEASE WAIT
PUT IN CARTRIDGE
Chapter 8
Error Code
Cause
#037
The MultiPASS C50's
memory is full because
it has received too
many documents, or a
very long or detailed
document.
The memory is full
because you sent too
many pages at once, or
a very long or detailed
document.
–
The MultiPASS C50 is
sending a fax and its
memory is full.
–
Shows how much of the
MultiPASS C50's
memory is in use.
#005
The receiving fax
machine does not
answer.
#022
The one-touch or
coded speed dialling
number has not been
registered.
–
In manual sending via
the handset, you tried
to use a one-touch
speed dialling button or
a coded speed dialling
code that has a group
registered in it.
–
The MultiPASS C50 is
warming up.
–
The BJ cartridge is not
installed properly.
Action
Print out any documents
that are stored in memory.
Then start the operation
again. See page 5-12.
Divide the document and
send each part separately.
If the memory contains any
faxes, you do not need to
delete them.
Wait until the fax is sent.
The MultiPASS C50
continues to send the fax
as memory becomes
available.
If you need more memory,
print or send any
documents stored in
memory.
Make sure you dialled the
correct number. Try again
later.
Register the number.
In manual sending via the
handset, you cannot send a
document to multiple
destinations. Send the
document to one
destination at a time.
Wait until the time and
receiving mode appear in
the LCD display, then
begin.
Make sure the BJ cartridge
is installed properly and
the green lock lever is set
properly.
Troubleshooting
8-33
Advertisement
Table of Contents
