Problems Feeding Paper Into The Sheet Feeder - Canon MultiPASSTM C50 User Manual

Problems Feeding Paper into the Sheet Feeder

If you are having problems feeding paper or other media into the MultiPASS
C50's sheet feeder, check the following table.
Whenever you correct one of these problems, be sure to remove the paper from
the sheet feeder and load it again. See page 2-45.
The following problems can also cause the paper to jam in the unit. See page 8-6
for instructions on clearing paper jams.
Problem
Paper does not feed into the
MultiPASS C50 sheet feeder
Printing is skewed
Chapter 8
Possible cause
The sheet feeder may contain
too many sheets.
Paper may not be inserted in
the sheet feeder correctly.
Paper may not be stacked
correctly in the sheet feeder.
Solution
Make sure the sheet feeder is
not filled past the limit mark
( ). See page 2-47.
Make sure paper is inserted all
the way into the sheet feeder.
See page 2-45.
Make sure the stack of paper is
straight in the sheet feeder.
Make sure the right side of the
stack of paper is aligned with the
right side of the sheet feeder,
and that the paper guide is
aligned against the left side of
the stack. See page 2-47.
Make sure the paper exit path is
clear.
Troubleshooting 8-9