Table of Contents
Advertisement
Problems Feeding Paper Into the MultiPASS C20 Sheet
Feeder
If you are having problems feeding paper or other media into the
MultiPASS C20's sheet feeder, check the following table.
N
Whenever you correct one of these problems, be sure to remove the
paper from the sheet feeder and load it again. See page 2-42.
The following problems can also cause the paper to jam in the unit. See
page 6-6 for instructions on clearing paper jams.
Problem
Paper does not feed
into the MultiPASS C20
Printing is skewed
Chapter 6
Possible cause
The sheet feeder may
contain too many sheets.
Paper may not be inserted
in the sheet feeder correctly.
Paper may not be stacked
correctly in the sheet feeder.
Solution
Make sure the sheet feeder
is not filled past the limit
mark (D). See page 2-45.
Make sure paper is inserted
all the way into the sheet
feeder. See page 2-43.
Make sure the stack of
paper is straight in the sheet
feeder.
Make sure the right side of
the stack of paper is aligned
with the right side of the
sheet feeder, and that the
paper guide is aligned
against the left side of the
stack. See page 2-45.
Make sure the paper exit
path is clear.
Troubleshooting
6-19
Advertisement
Table of Contents
