Adjustment Of The Electromechanical (Rem) Safety Stop Clutch - Access RPSP Installation Manual

Installation Manual – RPSP

5.7 Adjustment of the electromechanical (REM) safety stop clutch

As for the safety rail arms, the adjustment of the REM
clutch enables the opening and the closing of the platform,
avoiding possible overloads that could come about in the
event that:
 The platform encounters an obstacle during its opening
or closing movements
 The platform is moved manually by the user
For a proper adjustment of the clutch proceed as follows:
1. Perform a cycle of opening and closing of the platform
and verify that it opens/closes fully to its stop points.
2. If the platform does not fully open/close due to the
sliding of the clutch, act on the nut (4) turning it ¼
turn at a time until the proper tightening is obtained.
WARNING! ONCE THE PLATFORM HAS BEEN OPENED/CLOSED, THE REM CLUTCH MUST HAVE A SLIDING
PLAY OF A COUPLE OF MILLIMETRES. EXCESSIVE TIGHTENING STOPS THE CLUTCH FROM SLIDING,
MEANING THAT IT MUST BE LOOSENED TURNING IT ¼ TURN AT A TIME.
WARNING! EXCESSIVE TIGHTENING OF THE CLUTCH MAY CAUSE HARMFUL OVERLOADS ON THE
ACTUATOR.
Fig. 68 – Flap adjustment
Fig. 69 – Stop clutch adjustment
48
HIGHEST END POSITION
INTERMEDIATE POSITION
INS-RPSP-EN-05
4