Installation Manual – RPSP
4.2.3 Frame
Move the traction unit up again with the special
device so that it can be easily connected to the
frame-platform unit.
Using the support, bring the frame to the motor
unit.
Align the two components (both can be moved
along the guide) and connect them via the 12
screws and 2 nuts that had been previously
taken out (it is advisable to use thread locker).
After mounting the Traction unit to the Frame,
you can remove the self-supporting support.
Caution! The traction unit must be higher (by at least 1 cm) than the frame unit and the platform to
be connected.
Suggestion: To facilitate coupling between the Chassis and the Engine Unit, use the two self-
supporting fastening screws to "widen" the terminal parts of the chassis to ease positioning.
4.2.4 Frame Crush-Proofing
To mount the crush-proofing move the machine
from low stop.
Close the platform and access the lower part of
the frame.
Remove the self-supporting support.
With reference to figure, connect the support
(part 4) to the frame using the screws (part 9).
Fig. 36
Fig. 37 - Crush-proofing device
31
INS-RPSP-EN-05